Shenzhen Trunda Lighting Co., Ltd. Official Website Online message   About us  Contact us
Products Moer>>
 
Recommend Moer>>
 
Contact us Moer>>
Tel:+86 13501564296
Skype:13501564296
Email:Christy@trunda.com
Address: 10/F & 11/F , Jinyuanxing High-tech Industrial Park, No. 6 Industrial Park, Mashantou, Gongming Street, Guangming New District, Shenzhen
 
    News Center
Installation of lamps and lanterns
Welcome to read

Installation of lamps and lanterns:

1. Installation steps:

1. There are mounting holes on the base of lamps.

2. Pick up the base to the installation position.

3. Use a pen or other tool to make the screw opening on the wall.

4. Installation of base, upper stabilizing screw, etc.

5. Adjust the screw on the fixing clip and adjust the lamp to the appropriate irradiation angle.

6. There are three power lines at the bottom of the lamp. AC is the AC power input terminal, which is connected to the AC network. The blue line is zero N, the brown-red line is fire line L, and the yellow/yellow-green line is ground line PE.

Notes:

1. The lamp is waterproof and moisture-proof, and its protection level can reach IP65. It can withstand the test of rain from the top to the bottom, but can not be immersed in underwater work. Its protection level does not meet the requirements of underwater work.

2. The working power supply of lamps and lanterns is high voltage alternating current, which should be far away from the places easily touched by the crowd, and the earthing of lamps and lanterns should be done well, and the earthing wire must be earthed.

3. The lamp is a power type equipment, and is very sensitive to the ambient temperature. When the ambient temperature is higher than 45 degree C, the life of the lamp will decrease obviously, accompanied by serious surface signs of light decay. Therefore, the lamp should be placed in a ventilated and ventilated place, so as to keep the lamp in a good heat dissipation environment.

4. The working environment temperature of lamps and lanterns should be between -25 +45 C. The temperature in the workplace must not exceed 45 degrees C to ensure the service life of the lamps.

5. When distributing power supply lines, appropriate power supply lines should be selected according to actual power. The power supply is divided into two phases.


Last chapter:Installation instruction
Next chapter:Quality Appraisal of LED Spotlight

Contact us

Tel:+86 13501564296

Skype:13501564296

Email:Christy@trunda.com

Address: 10/F & 11/F , Jinyuanxing High-tech Industrial Park, No. 6 Industrial Park, Mashantou, Gongming Street, Guangming New District, Shenzhen